Table of Contents
Advertisement
Task 6: Configure server password and network addresses
Configure password
48
SAN32M-2 Installation and Service Manual
11. Select Exit from the File pull-down menu. A HyperTerminal
message box appears.
12. Click Yes. A second message box appears. Click No to exit and
close the application.
13. Power off the maintenance terminal and disconnect the RS-232
modem cable. Replace the protective cap over the maintenance
port.
14. At the product front panel, press and hold the IML/RESET
button for ten seconds to perform a POR.
15. Connect the product to the customer-supplied Ethernet LAN
segment or Ethernet hub:
a. Connect one end of the Ethernet patch cable (supplied) to the
RJ-45 connector (labelled 10/100).
b. Connect the remaining end of the cable to the LAN as directed
by the customer or to any available Ethernet hub port.
16. Go to
Task 6: Configure server password and network
Verify the LAN installation. If the server or equipment cabinet is
installed on a dedicated LAN, network information does not require
change. Change the default password for the server LCD panel (if
required by the customer), then go to
server
information.
If the server or equipment cabinet is installed on a public LAN, the
default password for the server LCD panel and the following
transmission control protocol internet protocol (TCP/IP) network
information must be changed to conform to the customer's LAN
addressing scheme:
•
IP address.
•
Subnet mask.
To configure a new LCD panel password:
addresses.
Task 7: Configure management
Advertisement
Table of Contents
