Table of Contents
Advertisement
Task 3: Unpack, inspect, and install the product
Unpack and inspect switch
a. To connect the top and middle stacked hubs, connect an RJ-45
patch cable to port 24 of the top hub, then connect the cable to
port 12 of the middle hub.
b. To connect the bottom and middle stacked hubs, connect a
second RJ-45 patch cable to port 24 of the middle hub, then
connect the cable to port 12 of the bottom hub.
c. As shown in the figure captioned
configuration
(1 and 2), use a pointed instrument to set the
medium-dependent interface (MDI) switch on the top and
middle hubs to MDI (in). As shown in
MDI switch on the bottom hub to MDIX (out).
NOTE: To connect two hubs, use the middle and bottom hub
instructions only.
6. Connect a power cord to a rack power strip and the receptacle at
the rear of each hub. Power for each hub switches on when the
hub (and equipment rack) are connected to facility AC power.
NOTE: Ensure each hub is connected to a separate rack power strip.
7. Inspect the front panel of each hub. Ensure each green Power LED
illuminates.
The following paragraphs provide instructions to unpack, inspect,
and install one or more switches.
Unpack and inspect the switch(es) as follows:
1. Inspect shipping container(s) for damage caused during transit. If
a container is damaged, ensure a representative from the freight
carrier is present when the container is opened.
2. Unpack shipping container(s) and inspect each item for damage.
Ensure the packaged items correspond to the items listed on the
enclosed bill of materials.
Patch cable and MDI selector
Figure 8
(3), set the
Chapter 2: Installation tasks
23
Advertisement
Table of Contents
