Table of Contents
Advertisement
Configure port NPIV
Configure SNMP
36
SAN32M-2 Installation and Service Manual
default value is 12 credits per port. Perform this procedure to
configure port receive BB_Credit:
3. Set all or a subset of user-specified ports offline. Refer to
state
or
Block or unblock a port
4. Select Ports and RX BB_Credit from the Configure menu at any
view. The RX BB_Credit View displays.
5. Perform one of the following:
— To set all offline ports to default values, click Default.
— To set an offline port to a user-specified value, type the desired
value in the RX BB_Credit column.
6. Click OK to save and activate changes.
7. Set all or user-specified ports online. Refer to
or
Block or unblock a port
NPIV allows multiple (up to 256) Fibre Channel addresses to be
assigned to a node (N_Port). The NPIV feature must be installed.
Refer to
Install PFE keys (optional)
procedure to configure ports for NPIV connectivity.
1. Select Ports and NPIV from the Configure menu at any view. The
NPIV View displays.
2. Click Enable to activate product NPIV operation.
3. To set a port to a user-specified value, type the desired value
(1 through 256) in the Login column.
4. Click OK to save and activate changes.
Perform this procedure to configure names, write authorizations,
addresses, and user datagram protocol (UDP) port numbers for
SNMP trap message recipients. To configure recipient workstations:
1. Select SNMP from the Configure menu at any view. The SNMP
View displays
(Figure
a. Click Enable to activate the installed SNMP agent.
for instructions.
(specified ports) for instructions.
for instructions. Perform this
17).
Set online
Set online state
(all)
Advertisement
Table of Contents
