Table of Contents
Advertisement
Event code: 083
Message:
Port set to inactive state.
Severity:
Informational.
Explanation:
A hardware or software problem prevented the port from coming online and set the port to an inactive state. Refer
to event data for the inactive reason
Action:
Action depends on inactive reason specified.
Event data:
The first byte of event data (byte 0) specifies the port number. The second byte (byte 1) specifies the inactive
reason code as follows:
2 = Feature key not enabled - The optional flexport PFE key is not enabled.
3 = Switch speed conflict - The port cannot operated at the configured product (backplane or CTP Card) speed.
4 = Optics speed conflict - The port transceiver does not support the configured port speed.
5 = No SBAR - A serial crossbar (SBAR) is not installed. Not applicable to IBM 2026 type switches.
6 = Port swap conflict - The port swap configuration is invalid.
Distribution:
Product
EFCM Basic
Event Log
Event code: 120
Message:
Error detected while processing system management command.
Severity:
Informational.
Explanation:
This event occurs when the switch receives a management command that violates specified boundary
conditions, typically as a result of a network error. The switch rejects the command, drops the switch-to-server
Ethernet link, and forces error recovery processing. When the link recovers, the command can be retried.
Action:
No action is required for an isolated event. If this event persists, perform a data collection and return the CD to
support personnel.
Event data:
No supplementary data included.
Distribution:
Product
EFCM Basic
Event Log
232
SAN32M-2 Installation and Service Manual
Management Server
System
Event Log
Error LED
Management Server
System
Event Log
Error LED
E-Mail
Call-Home
Sense Info
E-Mail
Call-Home
Sense Info
Host
Link Incident
Log
Host
Link Incident
Log
Advertisement
Table of Contents
