Table of Contents
Advertisement
Download firmware
154
SAN32M-2 Installation and Service Manual
— For approximately five seconds, continuously blow
compressed air or HFC-134a gas on exposed surfaces and the
end-face of the component.
4. Gently wipe the end-face and other surfaces of the component
with an alcohol pad (part 2 of
full contact with the surface to be cleaned. Wait approximately
five seconds for cleaned surfaces to dry.
5. Repeat steps two and three (second cleaning).
6. Repeat steps two and three (third cleaning).
7. Reconnect the fiber-optic cable to the optical transceiver.
The firmware version shipped with the product is provided on the
System Version XX.YY.ZZ CD-ROM. The SAN management
application (software) shipped with the product is provided on the
EFC Management Applications CD-ROM. Subsequent (upgrade)
firmware and software versions are provided to customers through
IBM.
NOTE: When upgrading firmware or software, follow all procedural
information contained in release notes or engineering change (EC)
instructions that accompany the version. Such information supplements
information provided in this general procedure.
1. To obtain the latest level of firmware, go to:
http://www.ibm.com/servers/storage/support/san/index.html.
Locate the link for this switch and then select the link for
downloading firmware.
2. Follow the instructions for downloading the firmware.
3. Transfer the downloaded firmware file to the rack-mount
management server or PC communicating with the EFCM Basic
Edition interface. Use a diskette, CD-ROM, or other electronic
means.
4. From there, install the firmware as described in this guide.
Figure
47). Ensure the pad makes
Advertisement
Table of Contents
