Table of Contents
Advertisement
1. Notify the customer the switch is to be set offline. Ensure the
customer's system administrator quiesces Fibre Channel frame
traffic through the switch and sets attached FC-AL devices offline.
2. Set the switch offline. For instructions, refer to
3. At the SAN management application's physical map, right-
click the product icon representing the switch for which a
configuration file is to be reset to factory default settings, then
select Element Manager from the pop-up menu. The application
opens.
4. At the Element Manager application (management server), select
Reset Configuration from the Maintenance menu. The Reset
Configuration dialog box displays
Figure 65
Reset Configuration dialog box
5. Click Reset to initiate the reset operation and close the dialog box.
6. The switch IP address resets to the default address of 10.1.1.10.
— If the configured IP address (prior to reset) was the same as the
default address, the switch-to-management server Ethernet
link is not affected and the procedure is complete.
— If the configured IP address (prior to reset) was not the same
as the default address, the switch-to-management server
Ethernet link drops and server communication is lost.
Continue to the next step.
7. To change the switch IP address and restart the management
server session, go to
session using the default IP address of 10.1.1.10:
a. Close the Element Manager application and return to the SAN
management application.
(Figure
65).
step
8. To restart a management server
Chapter 4: Repair information
Set online
state.
195
Advertisement
Table of Contents
