Punch Vertical Position Adjustment - Oce cm4521 User Manual

11
10
Check the print result.
– Check that the folding positions were adjusted.
– If more adjustment is necessary, repeat steps 6 through 9.
Note
Set the value by mm.
Refer to the conversion rate below.
1 in. = 25.4 mm

Punch Vertical Position Adjustment

The vertical position of punched holes when printing with a Punch setting
can be adjusted for each paper size.
Note
[Punch Vertical Position Adjustment] appears only if optional finisher
9833 or 9834 is installed.
For details on the Punch settings, refer to "Punching holes in copies
(Punch settings)" on page 2-92.
0 Before making any adjustments, use a Punch setting to print a sample
copy. Perform the adjustment while checking the sample that was
created.
1
Display the Administrator Settings screen.
– For details on displaying the Administrator Settings screen, refer to
"Displaying the Administrator Settings screen" on page 11-51.
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [3 Finisher Adjustment].
The Finisher Adjustment screen appears.
11-76
Utility mode
cm4521