11
6
Touch the button for the setting to be adjusted.
7
Check the stapling positions in the sample copy.
–
Touch [+] or [-] under "Adjust Value" to adjust the distance
(between 128 and 160 mm) between the staples.
–
Each time [+] or [-] is touched, the value is increased or decreased
by one increment.
8
Touch [OK].
The distance between the staples is adjusted.
If no adjustment of the distance between the staples was necessary in
step 7, this completes the procedure.
9
Use the "2 Position" Staple setting to print another sample copy.
10
Check the print result.
–
Check that the distance between the staples was adjusted.
–
If more adjustment is necessary, repeat steps 6 through 9.
Note
Set the value by mm.
Refer to the conversion rate below.
1 in. = 25.4 mm
11-66
Utility mode
cm4521