Specifying A Setting For Special Paper - Oce cm4521 User Manual

Copy paper/original documents
– If a decimal value is displayed in the screen and the specified value
is outside the allowable range, the message "Input Error" appears.
Type a value within the allowable range.
– If the orientation of the loaded paper does not match the sizes
specified for "X" and "Y", "Input error" appears, even if the values
are within the allowable range. In addition, do not enter the same
size for "X" and "Y".
– If the value was incorrectly entered, press the [C] (clear) key to
erase the value, and then specify the correct value.
To cancel changes to the settings, touch [Cancel].
8
Touch [OK], and then touch [OK] in the next two screens that appear.
The Basic screen appears again.
Note
The selected size button is programmed with the entered paper size, so
that the paper size is available to be selected again without being typed
in. In addition, the size can be changed.

Specifying a setting for special paper

If paper other than plain paper, such as OHP transparencies or special pa-
per, is loaded in a paper tray, be sure to change the paper type setting for
that tray.
The following procedure describes how to specify the setting for special pa-
per loaded into tray 1.
cm4521
6
6-21