11
10
Adjust the distance from the starting print position of the test pattern to
the edge of the paper.
–
Check that the distance has been adjusted to between 2.5 and 3.5
mm.
–
If more adjustment is necessary, repeat steps 8 and 9.
–
To adjust the print position for a different paper tray, return to step
6.
11
Touch [OK].
–
To cancel the setting and select the default, press the [Reset] key.
The print position is adjusted.
Note
Set the value by mm.
Refer to the conversion rate below.
1 in. = 25.4 mm
Leading Edge Adjustment (Duplex Side 2)
The starting print position at the leading edge for the second side during
automatic double-sided copying with each type of paper (with respect to the
paper feed direction) can be adjusted.
0 The starting print position is adjusted during manufacturing of the
machine. Normally, the starting print position will not need to be
adjusted.
1
Display the Administrator Settings screen.
–
For details on displaying the Administrator Settings screen, refer to
"Displaying the Administrator Settings screen" on page 11-51.
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [2 Printer Adjustment].
The Printer Adjustment screen appears.
5
Touch [3 Leading Edge Adjustment (Duplex Side 2)].
The Leading Edge Adjustment (Duplex Side 2) screen appears.
11-60
Utility mode
cm4521