11
10
Adjust the distance from the starting print position of the test pattern to
the edge of the paper.
–
Check that the distance has been adjusted to between 2.5 and 3.5
mm.
–
If more adjustment is necessary, repeat steps 8 and 9.
–
To adjust the print position for a different paper tray, return to step
6.
11
Touch [OK].
–
To cancel the setting and select the default, press the [Reset] key.
The print position is adjusted.
Note
Set the value by mm.
Refer to the conversion rate below.
1 in. = 25.4 mm
11-64
Utility mode
cm4521