Center Staple Position - Oce cm4521 User Manual

Utility mode

Center Staple Position

The stapling position when printing with the "Center Staple & Fold" setting
can be adjusted for each paper size.
Note
[Center Staple Position] appears only if optional finisher 9834 is installed
or if finisher 9821 is installed with the saddle stitcher attached.
If the angle of the staple must be adjusted, contact your service repre-
sentative.
The adjustment range differs depending on the finisher that is installed.
!
Detail
For details on the "Center Staple & Fold" setting, refer to "Binding copies
at the center ("Center Staple & Fold" setting)" on page 2-100.
For the procedure on adjusting the center folding position, refer to "Half-
Fold Position" on page 11-70.
0 Adjust the center folding position before adjusting the center stapling
position.
0 Before making any adjustments, use the "Center Staple & Fold" setting
to print a single sample copy. Perform the adjustment while checking the
sample that was created.
1
Display the Administrator Settings screen.
– For details on displaying the Administrator Settings screen, refer to
"Displaying the Administrator Settings screen" on page 11-51.
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [3 Finisher Adjustment].
The Finisher Adjustment screen appears.
cm4521
11
11-67