11
9
Check the print result.
–
Check that the angle of the punched holes was adjusted.
–
If more adjustment is necessary, repeat steps 6 and 7.
Note
Set the value by mm.
Refer to the conversion rate below.
1 in. = 25.4 mm
Punch Edge Sensor Adjustment
The sensors for detecting the paper edges when printing with a Punch
setting can be adjusted.
Note
[Punch Edge Sensor Adjustment] appears only if optional finisher 9833 or
9834 is installed.
For details on the Punch settings, refer to "Punching holes in copies
(Punch settings)" on page 2-92.
1
Display the Administrator Settings screen.
–
For details on displaying the Administrator Settings screen, refer to
"Displaying the Administrator Settings screen" on page 11-51.
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [3 Finisher Adjustment].
The Finisher Adjustment screen appears.
11-84
Utility mode
cm4521