Punch Regist Loop Size Adjustment - Oce cm4521 User Manual

11
9
Check the print result.
– Check that the horizontal position of the punched holes was
adjusted.
– If more adjustment is necessary, repeat steps 6 through 9.
Note
Set the value by mm.
Refer to the conversion rate below.
1 in. = 25.4 mm

Punch Regist Loop Size Adjustment

When printing with a Punch setting, the angle of punched holes along the
side of the paper can be adjusted.
Note
For details on the Punch settings, refer to "Punching holes in copies
(Punch settings)" on page 2-92.
The adjustment range differs depending on the finisher that is installed.
0 Before making any adjustments, use a Punch setting to print a sample
copy. Perform the adjustment while checking the sample that was
created.
1
Display the Administrator Settings screen.
– For details on displaying the Administrator Setting screen, refer to
"Displaying the Administrator Settings screen" on page 11-51.
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [3 Finisher Adjustment].
The Finisher Adjustment screen appears.
11-82
Utility mode
cm4521