Oce cm4521 User Manual page 721

11
– If the punch positions are too far blow the center of the paper, touch
[-] under "Adjust Value" to increase the adjustment (between -0.1
mm and -5.0 mm).
8
Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The vertical position of the punched holes is adjusted.
If no adjustment of the vertical position of the punched holes was
necessary in step 7, this completes the procedure.
9
Use a Punch setting to print another sample copy.
10
Check the print result.
– Check that the vertical position of the punched holes was adjusted.
– If more adjustment is necessary, repeat steps 6 through 9.
Note
Set the value by mm.
Refer to the conversion rate below.
1 in. = 25.4 mm
11-78
Utility mode
cm4521