Utility mode
6
Check the horizontal position of the punched holes.
–
To increase width A, touch [+] to increase the adjustment (between
0.1 mm and 5.0 mm).
–
Each time [+] or [-] is touched, the value is increased or decreased
by one increment.
–
To decrease width A, touch [-] to decrease the adjustment (between
-0.1 mm and -5.0 mm).
7
Touch [OK].
–
To cancel the setting and select the default, press the [Reset] key.
The horizontal position of the punched holes is adjusted.
If no adjustment of the horizontal position of the punched holes was
necessary in step 6, this completes the procedure.
8
Use a Punch setting to print another sample copy.
cm4521
A
A
11
11-81