Oce cm4521 User Manual page 712

Utility mode
– Each time [+] or [-] is touched, the value is increased or decreased
by one increment.
– If the staple position is too far to the right of the center of the paper,
touch [-] to reduce the adjustment.
8
Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The stapling position is adjusted.
If the stapling position was at the center of the paper in step 7, this
completes the procedure.
9
Use the "Center Staple & Fold" setting to print another sample copy.
10
Check the print result.
– Check that the stapling position is adjusted to the center of the
paper.
– If more adjustment is necessary, repeat steps 6 through 9.
cm4521
11
11-69