11
10
Check the distance from the starting print position of the test pattern
to the edge of the paper.
–
Check that the distance has been adjusted to 4.2 mm.
–
If more adjustment is necessary, repeat steps 8 and 9.
–
To adjust the print position for a different paper type, return to step
6.
11
Touch [OK].
The print position is adjusted.
Note
Set the value by mm.
Refer to the conversion rate below.
1 in. = 25.4 mm
Centering (Duplex 2nd Side)
The starting print position at the left edge of the paper for the second side
during automatic double-sided copying for each paper tray can be adjusted.
0 The starting print position is adjusted during manufacturing of the
machine. Normally, the starting print position will not need to be
adjusted.
0 Only 8-1/2 × 11 v paper can be used to adjust the bypass tray.
1
Display the Administrator Settings screen.
–
For details on displaying the Administrator Settings screen, refer to
"Displaying the Administrator Settings screen" on page 11-51.
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [2 Printer Adjustment].
The Printer Adjustment screen appears.
5
Touch [4 Centering (Duplex 2nd Side)].
The Centering (Duplex 2nd Side) screen appears.
11-62
Utility mode
cm4521