Stapling Copies (Staple Settings) - Oce cm4521 User Manual

Basic copy operations

Stapling copies (Staple settings)

Reminder
Copies can be fed out stapled either in the corner or at two places only
when the finisher is installed.
!
Detail
In order for the copies to be stapled, all of the following conditions must
be met.
The paper width must be between 7-3/16 inch and 12-1/4 inch.
The paper length must be between 5-1/2 inch and 18 inch.
If the "Mixed Original" setting is selected, all copies must be printed with
paper of the same width.
If a Staple setting is selected, the "Sort" setting is automatically selected.
A Staple setting cannot be used together with offset sorting.
If a Staple setting is to be selected, select the orientation in which the
document is positioned and the orientation of the page to be stapled,
otherwise the copies may not be stapled as desired.
For details on specifying the document orientation, refer to "Selecting the
document orientation (Original Direction settings)" on page 2-29.
Copies can be fed out stapled either in the corner or at two places.
cm4521
2
2-87