APPENDIX F
T1600 Router Cable Connector Pinouts
T1600 RJ-45 Connector Pinouts for the Routing Engine ETHERNET Port
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
T1600 RJ-45 Connector Pinouts for the Routing Engine ETHERNET Port on page 371
T1600 DB-9 Connector Pinouts for the Routing Engine AUXILIARY and CONSOLE
Ports on page 372
The port on the CIP labeled
receptacle that accepts an Ethernet cable for connecting the Routing Engine to a
management LAN (or other device that supports out-of-band management). Table 57
on page 371 describes the RJ-45 connector pinouts.
Table 57: RJ-45 Connector Pinouts
Pin
Signal
1
TX+
2
TX –
3
RX+
4
Termination network
5
Termination network
6
RX–
7
Termination network
8
Termination network
T1600 Connector Interface Panel (CIP) Overview on page 56
T1600 Chassis Description on page 14
Connecting the T1600 Router to a Management Console or Auxiliary Device on page 129
is an autosensing 10/100-Mbps Ethernet RJ-45
ETHERNET
371