Appendix F Cable Connector Pinouts; Rj-45 Connector Pinouts For The Routing Engine Mgmt Port; Connector Pinouts For The Routing Engine Aux/Modem And Console; Table 25: Rj-45 Connector Pinout - Juniper M10i Hardware Manual

Appendix F
Cable Connector Pinouts

RJ-45 Connector Pinouts for the Routing Engine MGMT Port

Table 25: RJ-45 Connector Pinout

Pin
1
2
3
4
5
6
7
8
This chapter describes the pinouts for the following cable connectors:
RJ-45 Connector Pinouts for the Routing Engine MGMT Port
DB-9 Connector Pinouts for the Routing Engine AUX/MODEM and CONSOLE
on page 200
Ports
RJ-48 Cable Pinouts for E1 and T1 PICs
X.21 and V.35 Cable Pinouts for EIA-530 PIC
RJ-21 Cable Pinouts for Fast Ethernet 12-Port PIC
The port on the Routing Engine labeled MGMT is an autosensing 10/100-Mbps Ethernet
RJ-45 receptacle that accepts an Ethernet cable for connecting the Routing Engine
to a management LAN (or other device that supports out-of-band management). For
more information, see "Routing Engine Interface Ports" on page 16. Table 25 on page
199 describes the RJ-45 connector pinout.
Signal
TX+
TX-
RX+
Termination network
Termination network
RX-
Termination network
Termination network
on page 200
on page 203
RJ-45 Connector Pinouts for the Routing Engine MGMT Port
on page 199
on page 205
199