Monitor And Maintain Interfaces - Dell Force10 S4810P Configuration Manual

Monitor and Maintain Interfaces

Monitor interface statistics with the
the interface status (up/down), number of packets, traffic statistics, etc.
Command Syntax
monitor interface
The information displays in a continuous run, refreshing every 2 seconds by default as shown in the
example below. Use the following keys to manage the output.
m - Change mode
T - Increase refresh interval (by 1 second)
q - Quit
FTOS#monitor interface gi 3/1
FTOS uptime is 1 day(s), 4 hour(s), 31 minute(s)
Monitor time: 00:00:00
Interface: Gi 3/1, Disabled, Link is Down, Linespeed is 1000 Mbit
Traffic statistics:
Input packets:
Output packets:
Over 64B packets:
Over 127B packets:
498
| Interfaces
Command Mode
EXEC Privilege
interface
l - Page up
Input bytes:
Output bytes:
64B packets:
command. This command displays an ongoing list of
monitor interface
Purpose
View the interface's statistics. Enter the type of interface and
slot/port information:
• For a 10/100/1000 Ethernet interface, enter the keyword
GigabitEthernet
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet
• For the Management interface on the RPM, enter the
keyword
information.
• For a SONET interface, enter the keyword
followed by slot/port information.
• For a 10 Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
c - Clear screen
a - Page down
t - Decrease refresh interval (by 1 second)
Refresh Intvl.: 2s
Current
0
0
0
0
0
0
0
followed by the slot/port information.
followed by the slot/port information.
followed by the slot/port
ManagementEthernet
followed by the slot/port
followed by the slot/port information.
Rate
0 Bps
0 Bps
0 pps
0 pps
0 pps
0 pps
0 pps
sonet
Delta
0
0
0
0
0
0
0