Multiple Users In Configuration Mode - Dell Force10 S4810P Configuration Manual

High-density, 1ru 48-port 10gbe switch

Hide thumbs Also See for Force10 S4810P:

Table of Contents

displays the output of the show command beginning from the first occurrence of specified text

Figure 2-11. Filtering Command Outputs with the find Command

FTOS(conf)#do show linecard all | find 0

terminal length

copies the output to a file for future reference.

Note: You can filter a single command output multiple times. The save option should be the last option

entered. For example:

| grep other-regular-expression | find regular-expression | save

Multiple Users in Configuration mode

FTOS notifies all users in the event that there are multiple users logged into CONFIGURATION mode. A

warning message indicates the username, type of connection (console or vty), and in the case of a vty

connection, the IP address of the terminal on which the connection was established. For example:

On the system that telnets into the switch,

Message 1 Multiple Users in Configuration mode Telnet Message

% Warning: The following users are currently configuring the system:

User "<username>" on line console0

On the system that is connected over the console,

Message 2 Multiple Users in Configuration mode Telnet Message

% Warning: User "<username>" on line vty0 "10.11.130.2" is in configuration mode

If either of these messages appears, Dell Force10 recommends that you coordinate with the users listed in

the message so that you do not unintentionally overwrite each other's configuration changes.

Configuration Fundamentals

shows this command used in combination with the command

displays additional configuration information.

displays the output all at once rather than one screen at a time. This is similar to the command

except that the

FTOS# command | grep regular-expression | except regular-expression

option affects the output of the specified command only.

show linecard all