Configuring Dcbx Globally On The Switch - Dell Force10 S4810P Configuration Manual

Step Task
6
On manual ports only:
Configure the Application Priority TLVs advertised on the
interface to DCBx peers, where:
•
fcoe
Priority TLVs.
•
iscsi
Priority TLVs.
Default: Application Priority TLVs are enabled to advertise
FCoE and iSCSI.
Note: To disable TLV transmission, enter the no form of the
command; for example, no advertise DCBx-appln-tlv iscsi.
For information about how to use FCoE and iSCSI, refer to
FIP Snooping

Configuring DCBx Globally on the Switch

To globally configure DCBx operation on a switch, follow these steps:
Step Task
1 Enter Global Configuration mode.
2 Enter LLDP Configuration mode to enable DCBx
operation.
3 Configure the DCBx version used on all interfaces not
already configured to exchange DCB information, where:
•
auto
version received from a peer.
•
cee
configures a port to use Cisco-Intel-Nuova (DCBx
cin
1.0).
•
ieee-v2.5
(Draft 2.5).
Default: Auto.
Note: You can configure the DCBx port role used by interfaces to exchange DCB information by using the DCBx
port-role command in INTERFACE Configuration mode (see Step 3 in
330
| Data Center Bridging (DCB)
enables the advertisement of FCoE in Application
enables the advertisement of iSCSI in Application
and
iSCSI Optimization.
configures all ports to operate using the DCBx
configures a port to use CEE (Intel 1.01).
configures a port to use IEEE 802.1Qaz
Command
[no] advertise
DCBx-appln-tlv {fcoe | iscsi}
Command
configure
[no] protocol lldp
[no] DCBx version {auto | cee
| cin | ieee-v2.5}
Configuring DCBx Globally on the
Command Mode
PROTOCOL LLDP
Command Mode
EXEC PRIVILEGE
CONFIGURATION
PROTOCL LLDP
Switch).