Important Points To Remember - S4810 Stacking - Dell Force10 S4810P Configuration Manual

Figure 47-6. Accessing Non-Master Units on a Stack via the Console Port
-------------------------------CONSOLE ACCESS ON THE STANDBY----------------------------------
2-unit-stack(standby)#?
cd
clear
copy
delete
dir
disable
enable
exit
format
package
pwd
rename
reset
show
ssh-peer-stack-unit
start
telnet-peer-stack-unit
terminal
upload
-------------------------------CONSOLE ACCESS ON A MEMBER-------------------------------------
Stack(stack-member-0)#?
reset-self
show
Stacking Cable Redundancy
You can connect two units with two or more stacking cables in case of a stacking port or cable failure.
Removal of only one of the cables does not trigger a reset.

Important Points to Remember - S4810 Stacking

• For S4810 stacking using 40GE ports, any remaining 40 GE ports should not be configured as
quad-mode.
• You may stack up to six S4810 systems
• The S4810 cannot be stacked with other system types.
• Stacking and Virtual Link Trunking (VLT)
• Data ports are configured as stacking ports in predefined groups of 4-10G ports called stack-groups.
When using the 40G ports, a single port can be configured as a stack port; each 40G port is a
stack-group.
• All the ports in a stack-group are placed in stacking mode. Unused ports in that group cannot be used
as data ports.
• The stack-group must contain only ports of the same type (all 10G or all 40G).
• Stacking with 1G interfaces is
• Stacking on the S4810 is accomplished through front end user ports on the chassis
• All stack units must have the same version of FTOS.
Change current directory
Reset functions
Copy from one file to another
Delete a file
List files on a filesystem
Turn off privileged commands
Turn on privileged commands
Exit from the EXEC
Format a filesystem
automation package related commands
Display current working directory
Rename a file
Reset selected card
Show running system information
Open a SSH connection to the peer Stack-unit
Start shell
Open a telnet connection to the peer Stack-unit
Set terminal line parameters
Upload file
Reset this unit alone
Show running system information
cannot
supported.
not
be enabled simultaneously on the S4810.
Stacking | 979