Dell Force10 S4810P Configuration Manual page 133

FTOS(config-route-map)#match metric 2000
In the above route-map, only if a route has both the characteristics mentioned in the route-map, it is
matched. Explaining further, the route must have a tag value of 1000 and a metric value of 2000. Only then
is there a match.
Also, if there are different instances of the same route-map, then it' s sufficient if a permit match happens in
any instance of that route-map. As an example:
FTOS(conf)#route-map force permit 10
FTOS(config-route-map)#match tag 1000
FTOS(conf)#route-map force deny 20
FTOS(config-route-map)#match tag 1000
FTOS(conf)#route-map force deny 30
FTOS(config-route-map)#match tag 1000
In the above route-map, instance 10 permits the route having a tag value of 1000 and instances 20 & 30
denies the route having a tag value of 1000. In the above scenario, FTOS scans all the instances of the
route-map for any permit statement. If there is a match anywhere, the route is permitted, though other
instances of the route-map denies it.
To configure match criterion for a route map, use any or all of the following commands in the
ROUTE-MAP mode:
Command Syntax
match as-path
as-path-name
match community
[ exact ]
community-list-name
Command Mode
CONFIG-ROUTE-MAP
CONFIG-ROUTE-MAP
Purpose
Match routes with the same AS-PATH numbers.
Match routes with COMMUNITY list attributes in
their path.
Access Control Lists (ACLs) | 133