Dell Force10 S4810P Configuration Manual page 455

Power Status : AC
Voltage : ok
Serial Number : FX000017082
--More--
2. The cache boot feature requires at least the boot code versions in
Requirements for Cache Boot," in High
verify that you have the proper version.
If you do not have the proper boot code version, the system displays a message similar to
you attempt to select a cache boot image (see
in the Release Notes for instructions on upgrading boot code.
Message 7 Boot Code Upgrade Required for Cache Boot Error
% Error: linecard 0 doesn't have cache boot aware bootCode.
Select the Cache Boot Image
Select the FTOS image that you want to cache using the command
example below. Dell Force10 recommends using the keyword
mis-matched configurations.
Note: The cache boot feature is not enabled by default; you must copy the running configuration to the
startup configuration (
enable it.
FTOS#upgrade system-image all A flash://FTOS-EF-7.8.1.0.bin
Current cache boot information in the system:
=============================================
Type A
---------------------------------------------------------
CP invalid
RP1 invalid[b][n]
RP2 invalid
linecard 0 invalid
linecard 1 is not present.
linecard 2 is not present.
linecard 3 is not present.
Availability. Use
Table 21-5. Boot Code Requirements for Cache Boot
Component
E-Series TeraScale RPM
E-Series TeraScale Line Card
E-Series ExaScale RPM
E-Series ExaScale Line Card
C-Series RPM
C-Series Line Card
Select the Cache Boot
copy running-config startup-config
B
invalid
invalid
invalid
invalid
Table 21-5, "Boot Code
and
show rpm show linecard
Boot Code
2.4.2.1
2.3.2.1
2.5.0.3
2.9.0.5
2.7.1.1
2.6.0.1
Image). See Upgrading the Boot Code
upgrade system-image
with this command to avoid any
all
) after selecting a cache boot image in order to
commands to
Message 7 when
, as shown in the
High Availability | 455