Configuration Task List For Ip Addresses; Implementation Information - Dell Force10 S4810P Configuration Manual

High-density, 1ru 48-port 10gbe switch

Hide thumbs Also See for Force10 S4810P:

Table of Contents

For more information on IP addressing, refer to

In FTOS, you can configure any IP address as a static route except IP addresses already assigned to

Note: FTOS versions 7.7.1.0 and later support 31-bit subnet masks (/31, or 255.255.255.254) as defined by

RFC 3021. This feature allows you to save two more IP addresses on point-to-point links than 30-bit masks.

FTOS supports RFC 3021 with ARP.

Configuration Task List for IP Addresses

The following list includes the configuration tasks for IP addresses:

Assign IP addresses to an interface

Configure static routes

Configure static routes for the management interface

For a complete listing of all commands related to IP addressing, refer to the

Reference Guide

Assign IP addresses to an interface

Assign primary and secondary IP addresses to physical or logical (for example, VLAN or port channel)

interfaces to enable IP communication between the E-Series and hosts connected to that interface. In

FTOS, you can assign one primary address and up to 255 secondary IP addresses to each interface.

IPv4 Routing

Internet Protoco

FTOS Command Line Interface