Dell Force10 S4810P Configuration Manual page 619

Using the
show interfaces port-channel c
FTOS#sh int port 10
Port-channel 10 is up, line protocol is up
Created by LACP protocol
Hardware address is 00:01:e8:09:c4:ef, Current address is 00:01:e8:09:c4:ef
Interface index is 1107755018
Minimum number of links to bring Port-channel up is 1
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 3000 Mbit
Members in this channel: Gi 3/21(U) Gi 3/22(U) Gi 3/23(U)
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 00:13:07
Queueing strategy: fifo
Input Statistics:
2189 packets, 278744 bytes
0 Vlans
0 64-byte pkts, 32 over 64-byte pkts, 2157 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
2189 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
2173 packets, 277350 bytes, 0 underruns
0 64-byte pkts, 19 over 64-byte pkts, 2154 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
2173 Multicasts, 0 Broadcasts, 0 Unicasts
0 Vlans, 0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec,
Output 00.00 Mbits/sec,
Time since last interface status change: 00:13:00
FTOS#
ommand to inspect LAG 10.
2 packets/sec, 0.00% of line-rate
2 packets/sec, 0.00% of line-rate
Indicates the MAC address assigned to the LAG.
This does NOT match any of the
physical interface MAC addresses.
Confirms the number of links to bring up
the LAG and that this is a switch
port instead of a router port.
Confirms the total bandwidth for this
LAG and which interfaces are active.
Link Aggregation Control Protocol (LACP) | 619