Assign An Ipv6 Address To An Interface - Dell Force10 S4810P Configuration Manual

The
default
• L3 ACL (ipv4acl): 6
• L2 ACL(l2acl) : 5
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 1
• L2 QoS (l2qos): 1
Save the new CAM settings to the startup-config (
new settings to take effect.
Command Syntax
cam-acl { ipv6acl }
show cam-acl
show cam-acl-egress

Assign an IPv6 Address to an Interface

IPv6 Addresses
Essentially IPv6 is enabled in FTOS simply by assigning IPv6 addresses to individual router interfaces.
IPv6 and IPv4 can be used together on a system, but be sure to differentiate that usage carefully. Use the
ipv6 address
When you configure IPv6 addresses on multiple interfaces (
configuration (
interface.
If the user attempts to configure more than two IPv6 addresses, the following error message appears:
Already configured maximum IPV6 addresses for this interface type
552
| IPv6 Routing
option sets the CAM Profile as follows:
Command Mode
CONFIGURATION
EXEC
EXEC Privilege
are supported on platforms
command to assign an IPv6 address to an interface.
command), the same link local (fe80) address is displayed for each IPv6
show ipv6 interfaces
or
write-mem copy run start
Purpose
Allocate space for IPV6 ACLs. Enter the CAM
profile name followed by the amount to be
allotted.
When not selecting the default option, you must
enter all of the profiles listed and a range for each.
The total space allocated must equal 13.
The ipv6acl range must be a factor of 2.
Show the current CAM settings.
Provides information on FP groups allocated for
the egress acl.
You must allocate at least one group for L2ACL
and IPv4 ACL.
The total number of groups is 4.
c e s
ipv6 address
) then reload the system for the
command) and verify the