Rip Configuration Example - Dell Force10 S4810P Configuration Manual

To enable RIP debugging, use the following command in the EXEC privilege mode:
Command Syntax
debug ip rip [
interface
Figure 40-6
Figure 40-6. debug ip rip Command Example
FTOS#debug ip rip
RIP protocol debug is ON
FTOS#
To disable RIP, use the

RIP Configuration Example

The example in this section shows the command sequence to configure RIPv2 on the two routers shown in
Figure 40-7
names. The screenshots are divided into the following groups of command sequences:
• Configuring RIPv2 on Core 2 on page 853
• Core 2 Output on page 853
• RIP Configuration on Core 3 on page 855
• Core 3 RIP Output on page 855
• RIP Configuration Summary on page 857
Figure 40-7. RIP Topology Example
GigE 2/41 GigE 2/41 10.200.10.0 /24
GigE 2/42 GigE 2/42 10.300.10.0 /24
Core 2
GigE 2/11 GigE 2/11 10.11.10.1 /24
GigE 2/31 GigE 2/31 10.11.20.2 /24
852
| Routing Information Protocol (RIP)
| database | events | trigger ]
shows the confirmation when the debug function is enabled.
no debug ip rip
— "Core 2" and "Core 3". The host prompts used in the example screenshots reflect those
GigE
2/31
Command Mode
EXEC privilege
command.
GigE
3/21
Purpose
Enable debugging of RIP.
GigE 3/43 192.168.1.0 /24 GigE 3/43
GigE 3/44 192.168.2.0 /24 GigE 3/44
Core 3
GigE 3/11 10.11.30.1 /24 GigE 3/11
GigE 3/21 10.11.20.1 /24 GigE 3/21