Dell Force10 S4810P Configuration Manual page 960

Dell Force10 provides additional MIB Objects to view copy statistics. These are provided in
Table 46-5. MIB Objects for Copying Configuration Files via SNMP
MIB Object
copyState
copyTimeStarted
copyTimeCompleted
copyFailCause
copyEntryRowStatus
To obtain a value for any of the MIB Objects in
Step Task
1 Get a copy-config MIB object value.
snmpset -v 2c -c public -m ./f10-copy-config.mib force10system-ip-address
•
index
Note: You can use the entire OID rather than the object name. Use the form: OID.index, as shown in
Figure 46-14
These examples assume that:
• the server OS is UNIX
• you are using SNMP version 2c
• the community name is public, and
• the file f10-copy-config.mib is in the current directory.
Note: In UNIX, enter the command snmpset for help using this command.
960
| Simple Network Management Protocol (SNMP)
OID
.1.3.6.1.4.1.6027.3.5.1.1.1.1.11
.1.3.6.1.4.1.6027.3.5.1.1.1.1.12
.1.3.6.1.4.1.6027.3.5.1.1.1.1.13
.1.3.6.1.4.1.6027.3.5.1.1.1.1.14
.1.3.6.1.4.1.6027.3.5.1.1.1.1.15
is the index value used in the
and Figure 46-15 are examples of using the command
Values
1= running
2 = successful
3 = failed
Time value
Time value
1 = bad file name
2 = copy in progress
3 = disk full
4 = file exists
5 = file not found
6 = timeout
7 = unknown
Row status
Table 46-5:
command used to complete the copy operation.
snmpset
Description
Specifies the state of the copy
operation.
Specifies the point in the up-time clock
that the copy operation started.
Specifies the point in the up-time clock
that the copy operation completed.
Specifies the reason the copy request
failed.
Specifies the state of the copy
operation. Uses CreateAndGo when
you are performing the copy. The state
is set to active when the copy is
completed.
[ |
OID.index mib-object.index
to obtain a MIB object value.
snmpget
Table 46-5.
]
Figure 46-15.