Dell Force10 S4810P Configuration Manual page 847

To control the source of RIP route information, use the following commands, in the ROUTER RIP mode:
Command Syntax
neighbor
ip-address
passive-interface
interface
Another method of controlling RIP (or any routing protocol) routing information is to filter the information
through a prefix list. A prefix lists is applied to incoming or outgoing routes. Those routes must meet the
conditions of the prefix list; if not, FTOS drops the route. Prefix lists are globally applied on all interfaces
running RIP. Configure the prefix list in the PREFIX LIST mode prior to assigning it to the RIP process.
For configuration information on prefix lists, see
Route-maps.
To apply prefix lists to incoming or outgoing RIP routes, use the following commands in the ROUTER
RIP mode:
Command Syntax
distribute-list
prefix-list-name
distribute-list
prefix-list-name
In addition to filtering routes, you can add routes from other routing instances or protocols to the RIP
process. With the
in the RIP process.
To add routes from other routing instances or protocols, use any of the following commands in the
ROUTER RIP mode:
Command Syntax
redistribute { connected | static } [ metric
] [ route-map
metric-value
redistribute isis [ level-1 | level-1-2 | level-2 ] [ metric
] [ route-map
metric-value
Command Mode
ROUTER RIP
ROUTER RIP
in
out
command syntax, you can include OSPF, static, or directly connected routes
redistribute
]
map-name
]
map-name
Purpose
Define a specific router to exchange RIP information
between it and the Dell Force10 system.
You can use this command multiple times to exchange
RIP information with as many RIP networks as you
want.
Disable a specific interface from sending or receiving
RIP routing information.
Chapter 17, IP Access Control Lists, Prefix Lists, and
Command Mode Purpose
ROUTER RIP Assign a configured prefix list to all incoming
RIP routes.
ROUTER RIP Assign a configured prefix list to all outgoing
RIP routes.
Command Mode
ROUTER RIP
ROUTER RIP
Purpose
Include directly connected or
user-configured (static) routes in RIP.
• range: 0 to 16
metric
• : name of a configured route
map-name
map.
Include IS-IS routes in RIP.
• range: 0 to 16
metric
• : name of a configured route
map-name
map.
Routing Information Protocol (RIP) | 847