Create A Multiple-Range; Exclude A Smaller Port Range; Overlap Port Ranges; Commas - Dell PowerEdge M IO Aggregator Command Reference Manual

Create a Multiple-Range

Figure 10-14. Creating a Multiple-Range Prompt
FTOS(conf)#interface range tengigabitethernet 3/0 , tengigabitethernet 2/1 - 47 , vlan 1000
FTOS(conf-if-range-te-2/1-47)#

Exclude a Smaller Port Range

If the interface range has multiple port ranges, the smaller port range is excluded from the prompt.
Figure 10-15. Interface Range Prompt Excluding a Smaller Port Range
FTOS(conf)#interface range tengigabitethernet 2/0 - 23 , tengigab 2/1 - 10
FTOS(conf-if-range-te-2/0-23)#

Overlap Port Ranges

If overlapping port ranges are specified, the port range is extended to the smallest start port number and
largest end port number.
Figure 10-16. Interface Range Prompt Including Overlapping Port Ranges
FTOS(conf)#inte ra tengig 2/1 - 11 , tengig 2/1 - 23
FTOS(conf-if-range-te-2/1-23)#

Commas

The example below shows how to use commas to add different interface types to the range, enabling all
Ten Gigabit Ethernet interfaces in the range 5/1 to 5/23 and both Ten Gigabit Ethernet interfaces 1/1 and 1/
2.
Figure 10-17. Multiple-Range Bulk Configuration Gigabit Ethernet and Ten-Gigabit Ethernet
FTOS(conf-if)# interface range tengigabitethernet 5/1 - 23, tengigabitethernet 1/1 - 2
FTOS(conf-if-range-te-5/1-23)# no shutdown
FTOS(conf-if-range-te-5/1-23)#

Monitor and Maintain Interfaces

You can display interface statistics with the
ongoing list of the interface status (up/down), number of packets, traffic statistics, etc.
command. This command displays an
monitor interface
Interfaces | 137