Monitor And Debugging Lacp - Dell Force10 S4810P Configuration Manual

To configure the LACP long timeout as shown in the example below:
Step Task
1 Set the LACP timeout value to 30 seconds.
FTOS(conf)# interface port-channel 32
FTOS(conf-if-po-32)#no shutdown
FTOS(conf-if-po-32)#switchport
FTOS(conf-if-po-32)#lacp long-timeout
FTOS(conf-if-po-32)#end
FTOS# show lacp 32
Port-channel 32 admin up, oper up, mode lacp
Actor System ID: Priority 32768, Address 0001.e800.a12b
Partner System ID: Priority 32768, Address 0001.e801.45a5
Actor Admin Key 1, Oper Key 1, Partner Oper Key 1
LACP LAG 1 is an aggregatable link
A - Active LACP, B - Passive LACP, C - Short Timeout, D - Long Timeout
E - Aggregatable Link, F - Individual Link, G - IN_SYNC, H - OUT_OF_SYNC
I - Collection enabled, J - Collection disabled, K - Distribution enabled L -
Distribution disabled,
M - Partner Defaulted, N - Partner Non-defaulted, O - Receiver is in expired
state,
P - Receiver is not in expired state
Port Gi 10/6 is enabled, LACP is enabled and mode is lacp
Actor Admin: State ADEHJLMP Key 1 Priority 128
Note: View PDU exchanges and the timeout value using the command
Debugging LACP.

Monitor and Debugging LACP

The system log (syslog) records faulty LACP actions.
To debug LACP, use the following command:
Command Syntax
[no] debug lacp [config | events |
pdu [in | out | [interface [in | out]]]]
Command Mode Purpose
EXEC Debug LACP, including configuration and events.
Command Syntax
lacp long-timeout
debug lacp
Link Aggregation Control Protocol (LACP) | 607
Command Mode
CONFIG-INT-PO
. See Monitor and