FTOS#show ip interface configured
FTOS#show ip interface linecard 1 configured
FTOS#show ip interface gigabitEthernet 1 configured
FTOS#show ip interface br configured
FTOS#show ip interface br linecard 1 configured
FTOS#show ip interface br gigabitEthernet 1 configured
FTOS#show running-config interfaces configured
FTOS#show running-config interface gigabitEthernet 1 configured
In EXEC mode, the
show interfaces switchport
their relevant configuration information. The
below displays the interface, whether the interface supports IEEE 802.1Q tagging or not, and the VLANs
to which the interface belongs.
FTOS#show interfaces switchport
Name: GigabitEthernet 13/0
802.1QTagged: True
Vlan membership:
Vlan
2
Name: GigabitEthernet 13/1
802.1QTagged: True
Vlan membership:
Vlan
2
Name: GigabitEthernet 13/2
802.1QTagged: True
Vlan membership:
Vlan
2
Name: GigabitEthernet 13/3
802.1QTagged: True
Vlan membership:
Vlan
2
--More--
Configure Interface Sampling Size
Use the
command, in INTERFACE mode, to configure the number of seconds of traffic
rate-interval
statistics to display in the
command displays only interfaces in Layer 2 mode and
show interfaces switchport
output.
show interfaces
command as shown in the example
Interfaces | 513