Configure Rip On Interfaces; Control Rip Routing Updates - Dell Force10 S4810P Configuration Manual

High-density, 1ru 48-port 10gbe switch

Hide thumbs Also See for Force10 S4810P:

Table of Contents

Figure 40-2. show ip rip database Command Example (Partial)

FTOS#show ip rip database

Total number of routes in RIP database: 978

160.160.0.0/16

29.10.10.0/24

192.162.2.0/24

192.161.1.0/24

192.162.3.0/24

To disable RIP globally, use the

Configure RIP on interfaces

When you enable RIP globally on the system, interfaces meeting certain conditions start receiving RIP

routes. By default, interfaces that are enabled and configured with an IP address in the same subnet as the

RIP network address receive RIPv1 and RIPv2 routes and send RIPv1 routes.

Assign IP addresses to interfaces that are part of the same subnet as the RIP network identified in the

command syntax.

By default, RIP broadcasts routing information out all enabled interfaces, but you can configure RIP to

send or to block RIP routing information, either from a specific IP address or a specific interface. To

control which devices or interfaces receive routing updates, you must configure a direct update to one

router and configure interfaces to block RIP updates from other sources.

Routing Information Protocol (RIP)