Removing A Command From Exec Mode; Move A Command From Exec Privilege Mode To Exec Mode; Allow Access To Configuration Mode Commands - Dell Force10 S4810P Configuration Manual

Removing a command from EXEC mode

Remove a command from the list of available commands in EXEC mode for a specific privilege level
using the command
than the level given to a user or terminal line, followed by the first keyword of each command to be
restricted.

Move a command from EXEC privilege mode to EXEC mode

Move a command from EXEC Privilege to EXEC mode for a privilege level using the command
from CONFIGURATION mode. In the command, specify the privilege level of the user or terminal
exec
line, and specify all keywords in the command to which you want to allow access.

Allow Access to CONFIGURATION mode commands

Allow access to CONFIGURATION mode using the command
CONFIGURATION mode. A user that enters CONFIGURATION mode remains at his privilege level, and
has access to only two commands,
mode command to which you want to allow access using the command
command, specify the privilege level of the user or terminal line, and specify all keywords in the command
to which you want to allow access.
Allow Access to INTERFACE, LINE, ROUTE-MAP, and ROUTER mode
1. Similar to allowing access to CONFIGURATION mode, to allow access to INTERFACE, LINE,
ROUTE-MAP, and ROUTER modes, you must first allow access to the command that enters you into
the mode. For example, allow a user to enter INTERFACE mode using the command
level level interface gigabitethernet
2. Then, individually identify the INTERFACE, LINE, ROUTE-MAP or ROUTER commands to which
you want to allow access using the command
the command, specify the privilege level of the user or terminal line, and specify all keywords in the
command to which you want to allow access.
The following table lists the configuration tasks you can use to customize a privilege level:
Task
Remove a command from the list of available commands
in EXEC mode.
Move a command from EXEC Privilege to EXEC mode.
Allow access to CONFIGURATION mode.
54
| Management
from CONFIGURATION mode. In the command, specify a level greater
privilege exec
and
end exit
privilege exec level level configure
. You must individually specify each CONFIGURATION
{ |
privilege interface line
Command Syntax
privilege exec level level
{ ||...||
command command
privilege exec level level
{ ||...||
command command
privilege exec level level configure
from
privilege configure level level
privilege configure
| | }
route-map router level level
Command Mode
CONFIGURATION
}
CONFIGURATION
}
CONFIGURATION
privilege
. In the
. In