Interface Types
Interface Type
Physical
Management
Loopback
Null
Port Channel
VLAN
View Basic Interface Information
The user has several options for viewing interface status and configuration parameters. The
command in EXEC mode will list all configurable interfaces on the chassis and has options to display the
interface status, IP and MAC addresses, and multiple counters for the amount and type of traffic passing
through the interface. If a port channel interface is configured, the
interfaces configured in the port channel.
Note: To end output from the system, such as the output from the
CTRL+C and FTOS will return to the command prompt.
Note: The CLI output may be incorrectly displayed as 0 (zero) for the Rx/Tx power values. Perform an
SNMP query to obtain the correct power information.
The following example displays the configuration and status information for one interface.
FTOS#show interfaces tengigabitethernet 1/0
TenGigabitEthernet 1/0 is up, line protocol is up
Hardware is Force10Eth, address is 00:01:e8:05:f3:6a
Current address is 00:01:e8:05:f3:6a
Pluggable media present, XFP type is 10GBASE-LR.
Medium is MultiRate, Wavelength is 1310nm
XFP receive power reading is -3.7685
Interface index is 67436603
Internet address is 65.113.24.238/28
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 10000 Mbit, Mode full duplex, Master
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 00:09:54
Queueing strategy: fifo
472
|
Interfaces
Modes
Possible
Default Mode
L2, L3
Unset
N/A
N/A
L3
L3
N/A
N/A
L2, L3
L3
L2, L3
L2
Requires
Creation
Default State
No
Shutdown (disabled)
No
No Shutdown (enabled)
Yes
No Shutdown (enabled)
No
Enabled
Yes
Shutdown (disabled)
Yes (except
L2 - No Shutdown (enabled)
default)
L3 - Shutdown (disabled)
show interfaces
show interfaces
show interfaces
command can list the
command, enter