Port Monitoring On E-Series; E-Series Terascale - Dell Force10 S4810P Configuration Manual

• The C-Series and S-Series may only have four destination ports per port-pipe. There is no limitation on
the total number of monitoring sessions.
Table 36-1
the total number of sessions is derived by consuming a unique destination port in each session, in each
port-pipe.
Table 36-1. Maximum Number of Monitoring Sessions per System
System
C150
C300
S50V, S50N
S25P
S55
S60
S4810
Note: On the C-Series and S-Series, there is no limit to the number of monitoring sessions per system,
provided that there are only 4 destination ports per port-pipe. If each monitoring session has a unique
destination port, then the maximum number of session is 4 per port-pipe.

Port Monitoring on E-Series

Both the E-Series TeraScale and E-Series ExaScale support the following.
• FTOS supports one destination (MG) port per monitoring session. The same destination port (MG) can
be used in another monitoring session.
• One destination (MG) port can monitor up to 28 source (MD) ports.
• A port cannot be defined as both a source (MD) and a destination (MG) port
Message 1 Cannot define source (MD) and destination (MG) on same port
% Error: MD port is already being monitored.

E-Series TeraScale

The E-Series TeraScale system supports 1 monitoring session per port-pipe. E-Series TeraScale supports a
maximum of 28 port pipes.
788
| Port Monitoring
lists the maximum number of monitoring sessions per system. For the C-Series and S-Series,
Maximum Sessions
∞
(Note)
∞
(Note)
∞
(Note)
∞
(Note)
∞
(Note)
∞
(Note)
∞
(Note)
System
E1200/E1200i (TeraScale)
E1200i (ExaScale)
E600/E600i (TeraScale)
E600i (ExaScale)
E300
Maximum Sessions
28
∞
14
∞
6
(Message 1).