Dell Force10 S4810P Configuration Manual page 71

Step Task
3 Assign the new location to the FTOS
image to be used when the system
reloads.
4 Assign an IP address to the
Management Ethernet interface.
5
6 Assign an IP address as the default
gateway for the system.
7 Reload the system.
Command Syntax
setenv [primary_image f10boot location |
secondary_image f10boot location |
default_image f10boot location
ipaddre address
setenv
setenv gatewayip address
reset
Command Mode
uBoot
]
uBoot
uBoot
uBoot
Management | 71