Configuration Task List For Is-Is; Configuration Information - Dell Force10 S4810P Configuration Manual

High-density, 1ru 48-port 10gbe switch

Hide thumbs Also See for Force10 S4810P:

Table of Contents

IS-IS Parameter

Complete Sequence Number PDU (CSNP) interval

IS-to-IS hello PDU interval

IS-IS interface metric

Metric style

Designated Router priority

Circuit Type

Equal Cost Multi Paths

To use IS-IS, you must configure and enable IS-IS in two or three modes: CONFIGURATION ROUTER

ISIS, CONFIGURATION INTERFACE, and ( when configuring for IPv6) ADDRESS-FAMILY mode.

Commands in ROUTER ISIS mode configure IS-IS globally, while commands executed in INTERFACE

mode enable and configure IS-IS features on that interface only. Commands in the ADDRESS-FAMILY

mode are specific to IPv6.

Note that by using the IS-IS routing protocol to exchange IPv6 routing information and to determine

destination reachability, you can route IPv6 along with IPv4 while using a single intra-domain routing

protocol. The configuration commands allow you to enable and disable IPv6 routing and to configure or

remove IPv6 prefixes on links.

Except where identified, the commands discussed in this chapter apply to both IPv4 and IPv6 versions of

Configuration Task List for IS-IS

The following list includes the configuration tasks for IS-IS:

Enable IS-IS on page 577

Configure Multi-Topology IS-IS (MT IS-IS) on page 580

Configure IS-IS Graceful Restart on page 581

Change LSP attributes on page 584

Configure IS-IS metric style and cost on page 585

Change the IS-type on page 587

Control routing updates on page 588

Configure authentication passwords on page 592

Intermediate System to Intermediate System

displays the default values for IS-IS.

IS-IS Default Values

Default Value

Level 1 and Level 2