Dynamic Arp Inspection - Dell Force10 S4810P Configuration Manual

View the number of entries in the table with the
displays the snooping binding table created using the ACK packets from the trusted port.
FTOS#show ip dhcp snooping binding
Codes : S - Static D - Dynamic
IP Address MAC Address
========================================================================
10.1.1.251 00:00:4d:57:f2:50
10.1.1.252 00:00:4d:57:e6:f6
10.1.1.253 00:00:4d:57:f8:e8
10.1.1.254 00:00:4d:69:e8:f2
Total number of Entries in the table : 4

Dynamic ARP Inspection

Dynamic ARP inspection prevents ARP spoofing by forwarding only ARP frames that have been validated
against the DHCP binding table.
ARP is a stateless protocol that provides no authentication mechanism. Network devices accept ARP
requests and replies from any device, and ARP replies are accepted even when no request was sent. If a
client receives an ARP message for which a relevant entry already exists in its ARP cache, it overwrites the
existing entry with the new information.
The lack of authentication in ARP makes it vulnerable to spoofing. ARP spoofing is a technique attackers
use to inject false IP-to-MAC mappings into the ARP cache of a network device. It is used to launch
man-in-the-middle (MITM), and denial-of-service (DoS) attacks, among others.
A spoofed ARP message is one in which the MAC address in the sender hardware address field and the IP
address in the sender protocol field are strategically chosen by the attacker. For example, in an MITM
attack, the attacker sends a client an ARP message containing the attacker's MAC address and the
gateway's IP address. The client then thinks that the attacker is the gateway, and sends all internet-bound
packets to it. Likewise, the attacker sends the gateway an ARP message containing the attacker's MAC
address and the client's IP address. The gateway then thinks that the attacker is the client and forwards all
packets addressed to the client to it. As a result, the attacker is able to sniff all packets to and from the
client.
Other attacks using ARP spoofing include:
• broadcast—an attacker can broadcast an ARP reply that specifies FF:FF:FF:FF:FF:FF as the gateway' s
MAC address, resulting in all clients broadcasting all internet-bound packets.
• MAC flooding—an attacker can send fraudulent ARP messages to the gateway until the ARP cache is
exhausted, after which, traffic from the gateway is broadcast.
show ip dhcp snooping binding
Expires(Sec) Type
172800 D
172800 D
172740 D
172740 D
Dynamic Host Configuration Protocol (DHCP) | 391
command. This output
VLAN Interface
Vl 10 Gi 0/2
Vl 10 Gi 0/1
Vl 10 Gi 0/3
Vl 10 Te 0/50