Ssh Over An Ipv6 Transport; Configuration Task List For Ipv6; Change Your Cam-Profile On An E-Series System - Dell Force10 S4810P Configuration Manual

SSH over an IPv6 Transport

IPv6 SSH
FTOS supports both inbound and outbound SSH sessions using IPv6 addressing. Inbound SSH supports
accessing the system through the management interface as well as through a physical Layer 3 interface.
Refer to the
configuration details.

Configuration Task List for IPv6

This section contains information regarding the following:
•

Change your CAM-Profile on an E-Series system

• Adjust your CAM-Profile on a C-Series or S-Series
• Assign an IPv6 Address to an Interface
• Assign a Static IPv6 Route
• Telnet with IPv6
• SNMP over IPv6
• Show IPv6 Information
• Clear IPv6 Routes
Change your CAM-Profile on an E-Series system
The
cam-profile
Change your CAM profile to the CAM
CAM profile is changed, save the configuration and reboot your router.
Command Syntax
cam-profile ipv6-extacl
microcode ipv6-extacl
| linecard slot
Figure 25-4
configured.
Memory (CAM), on page 273
550
| IPv6 Routing
is supported on platforms
chapter in the
Security Commands
command is supported only on platform
Command Mode
EXEC Privileged
chassis
displays the IPv6 CAM profile summary for a chassis that already has IPv6 CAM profile
Figure 25-5 shows the full IPv6 CAM profiles. Refer to
for complete information regarding CAM configuration.
c e s
FTOS Command Line Interface Reference
(mandatory)
e
before doing any further IPv6 configuration. Once the
ipv6-extacl
Purpose
Enable the CAM profile with IPv6 extended ACLs
on the entire chassis or on a specific linecard
chassis
in the chassis
linecard slot/port
the specified slot
document for SSH
changes the CAM profile for all linecards
changes the CAM profile only for
Chapter 11, Content Addressable