Dell Force10 S4810P Configuration Manual page 794

Figure 36-8. Configuring Flow-based Monitoring
FTOS(conf)#monitor session 0
FTOS(conf-mon-sess-0)#flow-based enable
FTOS(conf)#ip access-list
FTOS(config-ext-nacl)#seq 5 permit icmp any any count bytes
FTOS(config-ext-nacl)#seq 10 permit ip 102.1.1.0/24 any count bytes
FTOS(config-ext-nacl)#seq 15 deny udp any any count bytes
FTOS(config-ext-nacl)#seq 20 deny tcp any any count bytes
FTOS(config-ext-nacl)#exit
FTOS(conf)#interface gig 1/1
FTOS(conf-if-gi-1/1)#ip access-group
FTOS(conf-if-gi-1/1)#show config
!
interface GigabitEthernet 1/1
ip address 10.11.1.254/24
ip access-group testflow in
shutdown
FTOS(conf-if-gi-1/1)#exit
FTOS(conf)#do show ip accounting access-list testflow
!
Extended Ingress IP access list testflow on GigabitEthernet 1/1
Total cam count 4
seq 5 permit icmp any any monitor count bytes (0 packets 0 bytes)
seq 10 permit ip 102.1.1.0/24 any monitor count bytes (0 packets 0 bytes)
seq 15 deny udp any any count bytes (0 packets 0 bytes)
seq 20 deny tcp any any count bytes (0 packets 0 bytes)
FTOS(conf)#do show monitor session 0
SessionID
---------
794
| Port Monitoring
ext testflow
Source Destination
------ -----------
0 Gi 1/1 Gi 1/2
testflow in
Direction
---------
rx
monitor
monitor
Mode Type
---- ----
interface Flow-based