View Advanced Interface Information; Display Only Configured Interfaces - Dell Force10 S4810P Configuration Manual

High-density, 1ru 48-port 10gbe switch
Hide thumbs Also See for Force10 S4810P:
Table of Contents

Advertisement

FTOS(conf)# int gi 0/0
FTOS(conf-if)#neg auto
FTOS(conf-if-autoneg)# ?
end
exit
mode
no
show
FTOS(conf-if-autoneg)#mode ?
forced-master
forced-slave
FTOS(conf-if-autoneg)#
For details on the
Command Reference
Adjust the keepalive timer
Use the
keepalive
interface sends keepalive messages to itself to test network connectivity on the interface.
To change the default time interval between keepalive messages, use the following command:
Command Syntax
keepalive [
seconds
To view the new setting, use the

View Advanced Interface Information

Display Only Configured Interfaces

The following options have been implemented for
linecard interfaces. When the
configurations are displayed. Dummy linecard interfaces (created with the
like any other physical interface.
The following example lists the possible show commands that have the configured keyword available:
FTOS#show interfaces configured
FTOS#show interfaces linecard 0 configured
FTOS#show interfaces gigabitEthernet 0 configured
512
|
Interfaces
Exit from configuration mode
Exit from autoneg configuration mode
Specify autoneg mode
Negate a command or set its defaults
Show autoneg configuration information
Force port to master mode
Force port to slave mode
,
, and
speed
duplex
.
command to change the time interval between keepalive messages on the interfaces. The
]
show config
configured
commands, see the Interfaces chapter of the
negotiation auto
Command Mode
Purpose
INTERFACE
Change the default interval between keepalive
messages.
command in the INTERFACE mode.
show [ip | running-config] interfaces
keyword is used, only interfaces that have non-default
FTOS
commands for (only)
command) are treated
linecard

Advertisement

Table of Contents
loading

Table of Contents