Dell Force10 S4810P Configuration Manual page 736

Return to CONFIGURATION mode to enable the OSPF process. The OSPF Process ID is the identifying
number assigned to the OSPF process, and the Router ID is the IP address associated with the OSPF
process.
Command Syntax
router ospf
process-id
Once the OSPF process and the VRF are tied together, the OSPF Process ID cannot be used again in the
system.
If you try to enter an OSPF Process ID, or if you try to enable more OSPF processes than available Layer 3
interfaces, prior to assigning an IP address to an interface and setting the no shutdown command, you will
see the following message.
Message 1
C300(conf)#router ospf 1
% Error: No router ID available.
In CONFIGURATION ROUTER OSPF mode, assign the Router ID. The Router ID is not required to be
the router's IP address. Dell Force10 recommends using the IP address as the Router ID for easier
management and troubleshooting:
Command Syntax
router-id
ip address
Use the
no router ospf
Use the
clear ip ospf
Use the
show ip ospf
Figure 34-8.
FTOS#show ip ospf 55555
Routing Process ospf 55555 with ID 10.10.10.10
Supports only single TOS (TOS0) routes
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Number of area in this router is 0, normal 0 stub 0 nssa 0
736
| Open Shortest Path First (OSPFv2 and OSPFv3)
[vrf {vrf name}]
command syntax in the CONFIGURATION mode to disable OSPF.
process-id
command syntax in EXEC Privilege mode to reset the OSPFv2 process.
process-id
command in EXEC mode to view the current OSPFv2 status.
process-id
Command Example: show ip ospf
Command Mode Usage
CONFIGURATION Enable the OSPFv2 process globally.
Range: 0-65535
vrf name: Enter the VRF keyword and
instance name to tie the OSPF instance to
the VRF. All network commands under
this OSPF instance are subsequently tied
to the VRF instance.
Command Mode
CONFIG-ROUTER-O
SPF-id
process-id
Usage
Assign the Router ID for the OSPFv2
process.
IP Address: A.B.C.D