Show The Running-Configuration For An Interface - Dell Force10 S4810P Configuration Manual

Figure 25-8. Command Example:
FTOS#show ipv6 route summary
Route Source
connected
static
Total
Figure 25-9 illustrates the
Figure 25-9. Command Example:
FTOS#show ipv6 route static
Destination Dist/Metric, Gateway, Last Change
-----------------------------------------------------
S 8888:9999:5555:6666:1111:2222::/96 [1/0]
S 9999:9999:9999:9999::/64 [1/0]

Show the Running-Configuration for an Interface

View the configuration for any interface with the following command.
Command Syntax
show running-config
interface
type {slot/port}
Figure 25-10 illustrates the
show ipv6 route summary
Active Routes Non-active Routes
5 0
0 0
5 0
command output.
show ipv6 route static
show ipv6 route static
via 2222:2222:3333:3333::1, Gi 9/1, 00:03:16
via 8888:9999:5555:6666:1111:2222:3333:4444, 00:03:16
Command Mode
EXEC
command output. Note the IPv6 address listed.
show running-config
Purpose
Show the currently running configuration for the
specified interface
Enter the keyword
interface
interface and slot/port information:
• For a 10/100/1000 Ethernet interface, enter the
keyword
GigabitEthernet
port information.
• For a Gigabit Ethernet interface, enter the
keyword
GigabitEthernet
port information.
• For the Management interface on the RPM, enter
the keyword
ManagementEthernet
the slot/port information.
• For a 10 Gigabit Ethernet interface, enter the
keyword
TenGigabitEthernet
slot/port information.
• For a 40-Gigabit Ethernet interface, enter the
keyword followed by the slot/port
fortyGigE
information.
followed by the type of
followed by the slot/
followed by the slot/
followed by
followed by the
IPv6 Routing | 559