Show Interface - Dell Force10 S4810P Configuration Manual

Using the
Bravo#show int gig 3/21
GigabitEthernet 3/21 is up, line protocol is up
Port is part of Port-channel 10
Hardware is Force10Eth, address is 00:01:e8:09:c3:82
Current address is 00:01:e8:09:c3:82
Interface index is 140034106
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit, Mode full duplex, Master
Flowcontrol rx on tx on
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 00:15:05
Queueing strategy: fifo
Input Statistics:
708 packets, 89934 bytes
0 Vlans
0 64-byte pkts, 15 over 64-byte pkts, 693 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
708 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
705 packets, 89712 bytes, 0 underruns
0 64-byte pkts, 12 over 64-byte pkts, 693 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
705 Multicasts, 0 Broadcasts, 0 Unicasts
0 Vlans, 0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec,
Output 00.00 Mbits/sec,
Time since last interface status change: 00:12:39
618
| Link Aggregation Control Protocol (LACP)
command to inspect a LAG port on BRAVO.

show INTERFACE

0 packets/sec, 0.00% of line-rate
0 packets/sec, 0.00% of line-rate
Shows the status of this nterface.
Also shows it is part of LAG 10.
Shows that this is a Layer 2 port.
Shows the speed of this physical interface.
Also shows it is the Master of the GigE link.