Lacp Configuration Commands; Lacp Configuration Tasks - Dell Force10 S4810P Configuration Manual

LACP Configuration Commands

If aggregated ports are configured with compatible LACP modes (Off, Active, Passive), LACP can
automatically link them, as defined in IEEE 802.3, Section 43. The following commands configure LACP:
Command Syntax
[no] lacp system-priority
priority-value
[no] port-channel-protocol lacp
[no] port-channel number mode
[active | passive | off]
[no] lacp port-priority priority-value

LACP Configuration Tasks

The tasks covered in this section are:
• Create a LAG
• Configure the LAG interfaces as dynamic
• Set the LACP long timeout
• Monitor and Debugging LACP
• Configure Shared LAG State Tracking
Create a LAG
To create a dynamic port channel (LAG), define the LAG and then the LAG interfaces. Use the
and
port-channel
LAG 32:
FTOS(conf)#interface port-channel 32
FTOS(conf-if-po-32)#no shutdown
FTOS(conf-if-po-32)#switchport
Command Mode
CONFIGURATION
INTERFACE
LACP
LACP
commands, as shown in the following example, which uses the example of
switchport
Purpose
Configure the system priority.
Range: 1– 65535
(the higher the number, the lower the priority)
Default: 32768
Enable or disable LACP on any LAN port:
• Default is "LACP disabled"
• This command creates a new context.
Configure LACP mode.
• Default is "LACP active"
• number cannot statically contain any links
Configure port priority.
• Ranges: 1 – 65535
(the higher the number, the lower the priority)
• Default: 32768
Link Aggregation Control Protocol (LACP) | 605
interface